Back to Blog
How-to Guides 2026-11-02 Dwarven Forge - Miniature Terrain for the gaming community 1 views

45° Cave Passage Unpainted: How to Prep and Paint It

45° Cave Passage Unpainted: How to Prep and Paint It

Give the unpainted 45° Cave Passage a durable, table-ready finish with a simple wash, drybrush, and magnet check before it joins your cavern layout.

Quick answer

Wash and dry the unpainted 45° Cave Passage, prime it with a spray made for plastic or vinyl minis, then basecoat, wash, drybrush, and seal it. Work in thin layers so the passage's shape and anchor magnets stay clean and functional.

Why an unpainted passage is worth the extra work

An unpainted piece lets you match the exact rock and shadow tones of the rest of your cavern build instead of accepting a factory scheme. The trade-off is time: expect several thin coats and drying gaps between them, so paint two or three pieces in one session rather than rushing a single passage.

The 45° angle also means the piece is handled a lot as you rotate it into turns. A sealer coat matters more here than on a flat floor tile because edges and corners take the most contact.

Keep the magnets and fit surfaces clear

Anchor magnets are part of the piece's design, so avoid burying them under thick paint or primer. Mask or wipe the magnet faces and the mating edges before each coat dries, and test-fit the passage against a neighboring piece after sealing. If the fit feels tight, a light scrape of dried paint on the contact edge usually solves it.

Step-by-step: prep and paint the cave passage

  1. Clean and dry the piece: Rinse the unpainted passage in lukewarm water with a drop of mild dish soap, scrub gently with a soft brush, and let it air-dry completely. Common mistake: painting while moisture remains in recesses, which traps water under the primer. Dry time is part of the schedule; don't shortcut it.
  2. Prime in thin passes: Apply a plastic- or vinyl-compatible primer in two or three light passes from about 20–30 cm, rotating the piece between passes. Common mistake: one heavy coat that fills the passage's texture and magnet recesses. Two thin coats beat one wet coat every time.
  3. Basecoat the rock: Brush on a mid-tone gray-brown basecoat, thinning the paint slightly so it flows into crevices without pooling. Checkpoint: the basecoat should be opaque enough that the primer no longer shows through on raised faces. Stop when the primer is hidden, not when the paint is thick.
  4. Wash the recesses: Apply a dark wash into the passage's crevices and along the floor edges, then wick away excess with a clean brush. Common mistake: letting wash pool on flat surfaces, which leaves tide marks after drying. Work one section at a time so the wash stays movable.
  5. Drybrush the highlights: Load a dry brush lightly with a lighter rock tone and drag it across raised edges and the passage mouth. Checkpoint: highlights should catch only the top surfaces, not the recesses you just darkened. If the brush feels wet, wipe more paint off before touching the piece.
  6. Seal and test-fit: Apply a matte varnish in thin coats, then check that the anchor magnets and mating edges are clean and that the passage seats flush against a neighboring piece. Common mistake: sealing over magnet faces or contact edges, which can interfere with the fit. Do a fit check before the piece goes back in the storage bin.

Product facts

  • 45¬∞ Cave Passage (Unpainted): Unpainted individual piece from the Caverns line and KS6 range, with anchor magnets noted in the product tags. You control the final color scheme, and the magnets let the passage lock into a larger cavern layout once the paint is sealed.
    45° Cave Passage (Unpainted)
    45° Cave Passage (Unpainted)

Related Articles

Customer Service
Home
Products
Cart
Profile