How to Use Sensor Arm Pole Accessory for Terrain
By Dwarven Forge - Miniature Terrain for the gaming community | Published: 2026-10-27
Category: How-to Guides
Learn how to attach, position, and paint the Sensor Arm pole accessory for your Dwarvenite terrain. Step-by-step guide for stable sci-fi setups.
Quick answer
Attach the unpainted Sensor Arm pole accessory to compatible Dwarvenite terrain tiles using the built-in peg, then paint it to match your sci-fi setup for a stable, elevated sensor point.
Why the Sensor Arm needs prep before play
The Sensor Arm comes unpainted, which means you have full control over its final look but also need to seal and paint it before regular use. Raw Dwarvenite can pick up scuffs and dust, and the unpainted surface may not blend with your existing terrain.
Because it is a pole accessory, stability depends on how you attach it. The peg fits into standard Dwarvenite holes, but if your tile has a textured surface or an uneven slot, you may need a small dab of poster putty to keep it upright during gameplay.
Common mistake: forcing the peg into a non-compatible tile
The Sensor Arm peg is designed for Dwarvenite tiles with round accessory holes. Trying to force it into a square slot or a tile without a hole can break the peg or damage the tile. Always check that your terrain piece has a compatible opening before pressing it in.
How to set up your Sensor Arm pole accessory
- 1. Inspect the peg and the tile hole: Check that the peg on the Sensor Arm is clean and free of flash. Test-fit it into the accessory hole on your Dwarvenite tile. If it is tight, do not force it; sand the peg lightly with fine-grit sandpaper. A tight fit is better than a loose one, but forcing can crack the peg.
- 2. Attach the Sensor Arm to the terrain: Press the peg straight into the hole until it seats fully. If the arm wobbles, remove it and apply a tiny dab of poster putty or blue tack to the peg before reinserting. Test stability by gently tapping the arm from the side before placing miniatures near it.
- 3. Prime and paint the unpainted surface: Clean the Sensor Arm with mild soap and water, let it dry, then apply a thin coat of primer designed for plastic or resin. Once dry, paint it with acrylics to match your terrain. A drybrush over the sensor head adds detail. Seal the paint with a matte varnish to protect the finish during handling.
- 4. Position the sensor for gameplay: Place the assembled tile and Sensor Arm on the table. Use the arm as a line-of-sight marker, objective point, or decorative antenna. Because it is a single pole, keep it away from heavy miniatures that might knock it over. If you need multiple sensor points, buy two or three arms and paint them together for a uniform look.
Product fact
- Sensor Arm - Pole Accessory (Unpainted): The Sensor Arm is a pole accessory from Dwarven Forge, offered as an individual piece in the Starforged sci-fi line. It is sold unpainted, so you can finish it to match your existing terrain and miniatures. You can customize the color and weathering to fit your sci-fi tabletop, but you will need to paint it before it looks finished on the board.
Sensor Arm - Pole Accessory (Unpainted)
